About us | Downloads | Career | Fair & Exhibition
 
 
Powder Coating PROCESS (G-COAT 600)

   

G-COAT™ (Polyether Ketone) 600 Series electrostatic coating powder are available where higher thickness coatings are required, where difficult geometries must be coated, and in instances where enhanced properties such as release are required.
G-COAT™ 600 powder coatings can be used in traditional electrostatic coating equipment either in manual or automatic powder booths using a negative corona charges. The gun, powder transforming lines and fluidizing unit should be completely covered and cleaned to remove all vestiges of other powder prior to charging the system with G-COAT™ Coatings, otherwise coating defects such as black specks, pin holes, and craters will be evident in the finished coating surface. The fluidizing unit should be capable of providing a steady stream of powder to the gun without slugging. The compressed air supply to the unit should be filtered and dried to remove any contaminants from the compressor.

Click below link to download G-COAT™ 600 Process User Guides User Guides


G‐COAT™ 600 ( Electrostatics Powder)

 
         
Our Polymers   Industry   Quick Contact
     
G-PAEKTM - Polyether Ketone
G-COATTM - Surface Coating of Polyether Ketone
Speciality Application
GAPEKKTM - Polyether Ketone Ketone
GAZOLETM - Polybenzimidazole
 
Industrial Transportation
Electricals & Electronics Alternative Energy
Oil & Gas Energy Aircraft & Aerospace
Medical Other Industries
Food  
Name:
Contact No.:
Email:
Requirement:
 
   
 

 

All rights reserved. © 2013.Gharda Plastics Website Powered by Creative Globe